Solar Charge Controller (GS-B1 10A)

Solar controller for PV systems, coordination of solar panels, batteries and work load, is a very important photovoltaic system component. It makes the whole solar system work efficiently and safely. Solar street light controller is mainly used for domestic, commercial, factory, transport, pastoral areas, communication and other photovoltaic power systems.
Features: 1. Using a single chip and special software achieve the intelligent control.

2. Using of battery discharge rate characteristics modify the discharge control. Final dischargevoltage is the control point modified by discharge curve to eliminate the inaccuracies by a simple over discharge voltage. In accord with inherent characteristics of the battery, different discharge rates has the different final discharge voltage to ensure the battery to be used effectively.

3. Over charge, over discharge, short circuit, overload protection, reverse polarity protection, reverse current protection at night, automatic control and so on; More protection from damaging any parts and burning insurance out.

4. Adopting series connected type PWM as the main circuit, the voltage loss of the charge loop lower nearly half compared with the circuit using the diode's charge reduced; In contrast to non-PWM, the charge efficiency is higher 3% - 16%; An increase of power utilization time; Normal direct charging; Automatically control of float charging make sure the system with long lifespan.

5. Accurate temperature compensation.
6. Intuitive LED indicates the current battery status to make sure that users understand the behavior in service.
7. Cancel set point adjustment and control of potentiometer, and use of Flash memory to record the work control points to set the digitization to eliminate the vibration due to deviation and reduce errors and reliable factors by drift and other control points.
8. Using of soft- touch keys is convenient and aesthetic.

Technical specification

Table of Product Parameter
Model: GS-B1 10A
Fixed charging current: 10A
Rated load electric current: 10A
System Voltage: 12V24V
Over-load protection: >1.25 multiple Nominal current30 seconds or >1.5 Multiple Nominal current1 seconds, and >2.5 Multiple Nominal current, Over-loadprotection movement
No-load loss: <6mA
Charging circuit voltage drop: ≤ 0.26V

Load circuit voltage drop: ≤ 0.15V
Over voltage protection: 17V /12V; 34V /24V
Work temperature: Technical grade: -35 degree to +55 degree
Boost charge voltage: 14.8V; X2/24V(keep 10-min) (only applied when over discharge appears)
Direct charge voltage: 14.4V; X2/24V(keep 10-min)
Float charge voltage: 13.6V; X2/24V(keep working until drop to the point of charge return voltage action)
Charge return
Voltage: 13.2V; × 2/24V;
Temperature
Compensation: -5mV/ degree/2V
Lower voltage indicate: 11.2V; X2/24V
Over discharge voltage: 10.6V no load-real-time modified voltage by the discharge rate; X2/24V
Over discharge return voltage: 11.8V; 2/24V
Control mode: The way of PWM Pulse-duration modulation